ENGEL WIRELESS THERMOMETER
Model: ENGTHERM
Instruction Manual
Inventory
of
content
1. The receiver unit display
2. The remote sensor
3. Instruction Manual
4. Lead Clip
5. Adhesive Hook & Loop
Function:
•
Clock
•
Ambient temperature
•
Fridge temperature
•
Min/Max record of temperature
Quick
Setup
Note: Use good quality alkaline batteries and avoid rechargeable batteries.
1. Place the batteries into the remote sensor first; then into the receiver
unit.
2. DO NOT P R E SS A N Y KEY BEFORE R E C E I V E R U N I T
D I S P L A Y S
THE DATA FROM THE REMOTE SENSOR.
After both
ambient and fridge data are displayed you can place your remote sensor on
outside of your fridge and set the current time. Place the sensor wire into your
fridge.
** If the fridge temperature reading is not found on the receiver unit, make sure
the units are within range of each other or repeat the battery
installation procedure. If a key is pressed before the receiver unit receives the
fridge temperature signal, you will need to follow the battery installation
procedure again. WAIT 10 SECONDS BEFORE RE-INSERTING THE
BATTERIES TO ENSURE A PROPER RESET.
Setting
Operation
1. Set Time
Press the SET key for 2 seconds, 24H will be displayed. Press + key to
select 24H or 12H time display mode. Press SET key to confirm display mode
selection. If 24H mode selected, temperature will be displayed in degrees
Fahrenheit, if in 12H mode, temperature will be displayed in degrees Celsius.
To Next Page
Need help?
General