To Next Page

To Previous Page

INSTALLING HANDLES

Lifting handles are furnished with larger models (MT35F-U1D-P, MT45F-U1D-P) and

are packed loose inside the refrigerator. They are to be installed using the screws

and tapped holes provided.

CONNECTING TO THE POWER SOURCE

120 VOLT AC OPERATION IN YOUR HOME

Your refrigerator needs so little power that it may be connected to any AC 120V

receptacle in your home. To do this, set the thermostat control knob to "OFF" and

insert the square plug of the AC cord in the connector on the refrigerator and the

standard plug in a wall socket in your home. The power consumption is less than a

standard light bulb.

12/24 VOLT DC OPERATION IN YOUR CAR, TRUCK, SUV, BOAT, TRAILER,

RV, ETC.

Battery voltage varies with the type of car / truck / SUV / boat / RV you own. Most

cars, trucks and boats use a 12 Volt system. Your refrigerator needs either a 12 Volt

or a 24 Volt battery with a negative ground.

Cover

For Japanese

＋

American

＋

Australian built vehicles

For European built vehicles (option) accessory

Set the thermostat control knob to "OFF" and insert one end of the DC Cord / Plug

(provided with the refrigerator) into the connector and the other end into the power

port of your car. In most passenger cars, the power port is on the dashboard.

NOTE: When not using the refrigerator, remove the plug from the power port to

prevent discharge of your car battery.

Most SUVs and minivans have a dedicated power port in the rear of the vehicle to

make connecting the refrigerator easier.

Engel MT45F-U1D-P User Manual

Other manuals for Engel MT45F-U1D-P