Assembly - Step 5: Charging the Battery
Remove the charger from the box, attached the power cord and insert that to any
wall outlet. Insert the plug at the end of the smaller cable into the charging terminal
of the battery and start charging. The charging terminal is on the side of the battery
opposite to a hole on the side of the frame. The LED on the charger glows RED
while charging and glows GREEN when charging is complete. The battery should
be turned OFF while being charged. When the LED on the charger turns Green,
disconnect the charging cord and cover the charging terminal with the rubber cap.
If a battery is installed on the e-bike and turned ON, the display panel will show the
charge level of the battery when the bike turned ON.
You are now ready to start using your e-bike.
To Next Page
Loading...
