ENNOLOGIC TRUE RMS MULTIMETER EM860T-QUICK-START GUIDE
1
Open the Package
When you open the package, you
should nd your multimeter along
with a 9V battery, two test leads, and
a thermocouple probe - all packed in
a carrying case.
1
Install the Batteries
Disconnect any test leads or connectors from the
terminals.
Remove the red protective rubber casing by carefully
peeling it away from the black plastic enclosure.
Then use a screwdriver to unscrew the two screws
on the battery cover, on the back of the unit near the
bottom. Remove the battery cover from the meter.
Install the 9V battery, replace the battery cover and
tighten the screws.
Reattach the protective rubber casing.
2
EnnoLogic True RMS Multimeter eM860T
Quick-Start Guide
WHEN YOUR TRUE RMS MULTIMETER ARRIVES
To Next Page
Need help?
General
