23
Enphase Energy System with IQ Battery 5P Owner’s Guide
Risk of equipment damage. During use, storage,
transport, or installation, always keep the
Enphase Energy System equipment in an upright
(top side up) position.
Do not install or use the Enphase Energy System
equipment if it has been damaged in any way.
Do not place beverages or liquid containers on
top of the Enphase Energy System equipment. Do
not immerse Enphase Energy System equipment in
liquids or ooding.
Protection against lightning and resulting voltage
surge must be in accordance with local standards.
IQ Battery 5P is intended to operate with an
internet connection. A Wi-Fi or Ethernet primary
internet connection is required to ensure
consistent connectivity.
During use, storage, and transport, keep Enphase
Storage products:
Using unapproved attachments or accessories
could result in damage or injury.
• Properly ventilated
• Away from heat, sparks, and direct sunlight
• Away from excessive dust, corrosive and
explosive gases, oil, and smoke
• Away from direct exposure to gas exhaust,
such as from motor vehicles.
• Free of vibrations
• Away from falling or moving objects, including
motor vehicles
• At an elevation of fewer than 2500 meters
(8200 feet) above sea-level
• In a location compliant with re safety
regulations (has a smoke detector)
• In a location compliant with local building
codes and standards
To ensure optimal reliability and to meet warranty
requirements, Enphase Energy System equipment
must be installed and/or stored according to the
instructions in Enphase Energy System equipment
guides.
Read this entire document before using Enphase
Energy Systems.
Do not sit on, place objects on, or insert objects
into the Enphase Energy System equipment.
The IQ Gateway must properly be tted with
Enphase Production CT and Consumption CTs.
An IQ Gateway and a Communications Kit 02 are
required for the operation of the IQ Battery 5P
units.
To Next Page
Loading...
