ENSONIQ ZR-76 - Page 42

To Next Page

To Previous Page

Chapter 3ÑGlobal Settings

ENSONIQ ZR-76 Musician's Manual 33

3. Press Yes if youÕd like to change the current system preferences. Press No if youÕd like to cancel the

procedure.

4. Turn the Parameter knob until the display shows:

System Preferences:

Press Threshold= Med

The current Press Threshold value

If you would like to make it easy to generate keyboard pressure by pressing on the keys, set the

parameter to Soft. If you would like to make it more difficult to generate keyboard pressure by

pressing on the keys, set the parameter to Hard. Try different settings to find the one most

comfortable for you.

5. Turn the Value knob or press the up/down arrow buttons to set the Touch Curve parameter to the

value that best matches your playing style.

This parameter affects the way your ZR-76 responds to pressure internally, as well

as the pressure values it transmits via MIDI.

ÕÕ

The rear panel of the ZR-76 offers four audio outputs. There are two stereo pairs: the Main Outs and the

Aux Outs.

The Main Outs are used as the primary feed from the ZR-76. The Aux Outs are useful for extracting

sounds or groups of sounds from the ZRÕs Main Out mix. By routing a sound to the Aux Outs, you can

treat it to its own outboard processing, or control its volume individually by assigning it to its own fader

on a mixer. Use standard balanced (TRS stereo cables) or unbalanced (TS mono cables) for the Main and

Aux Outs.

As the labels on the Aux Out jacks and Main Out jacks indicate, the ZR-76 employs automatic switching

on each pair of outputs:

¥ Main Outputs Left and Right are normally stereo outputs. However, if nothing is plugged into the

Right Output, the stereo signal will be summed to mono and sent to the Left Main Output.

¥ Similarly, the Aux Outputs Left and Right are normally stereo outputs. However, if nothing is plugged

into the Right Aux Output, the stereo signal will be summed to mono and sent to the Left Aux Output.

All tracks sounds are routed to a rear-panel output via an effect bus. In routing a sound to a particular

pair of outs:

¥ The sound is assigned to an FX bus.

¥ The bus goes to an effect (except the dry bus, which goes directly to the outputs you choose).

¥ The effect is assigned to either the Main Outs or the Aux Outs.

When you change any system setting, ZR-76 operations will pause momentarily

to store your settings into FLASH memory.

Other manuals for ENSONIQ ZR-76