ENSONIQ ZR-76 - Page 43

To Next Page

To Previous Page

Chapter 3ÑGlobal Settings

ENSONIQ ZR-76 Musician's Manual34

1. If youÕre using SoundFinder, select the sound youÕd like to send to a particular output and route it to

an effect bus. (To learn how to route a SoundFinder sound to an effect bus, see Chapter 8.)

If youÕre using the 16 Track Recorder, press the track button containing sound youÕd like to send to

a particular output, and route it to an effect bus. (To learn how to route a sound on a track to an

effect bus, see Chapter 8.)

2. Press the System button.

3. Turn the Parameter knob until the display shows:

System/MIDI:

Set system prefs?

4. Press Yes if youÕd like to change the current system preferences. Press No to cancel the procedure.

5. Turn the Parameter knob until the display shows the output assign parameter for the FX bus youÕve

chosen.

The LightReverb, Medium Reverb and WetReverb busses all use the

GlobalReverbOut parameter.

6. Use the Value knob to select either the Main or Aux Outs.

When you change any system setting, ZR-76 operations will pause momentarily

to store your settings into FLASH memory.

1. Press the System button.

2. Turn the Parameter knob until the display shows:

System/MIDI:

Set system prefs?

3. Press Yes if youÕd like to change the current system preferences, or No to cancel the procedure.

4. Turn the Parameter knob until the display shows the name of the Effect Bus you would like to assign

to an output.

System Preferences:

Insert FX Out= Main

The name of the effect bus The current output assignment

Other manuals for ENSONIQ ZR-76