ENSONIQ ZR-76 - Page 46

To Next Page

To Previous Page

Chapter 3ÑGlobal Settings

ENSONIQ ZR-76 Musician's Manual 37

setting when selecting new split or layer sounds in SoundFinder, or track sounds in the 16 Track

Recorder.

When you select a new split or layer sound in SoundFinder:

¥ with AutoSelect FXBus on, the sound you choose will be routed to its Alt. FX Bus

¥ with AutoSelect FXBus off, the split or layer effect bus setting will remain unchanged when you

select the new sound

After youÕve selected a split or layer sound, you can manually change its effect bus

as you please, regardless of the setting of the AutoSelect FXBus parameter.

In the 16 Track Recorder, when you select a sound for a new, undefined track:

¥ with AutoSelect FXBus on, the sound you choose will be routed to its Alt. FX Bus

¥ with AutoSelect FXBus off, the track will be set to the effect bus routing currently being used in

SoundFinder

After youÕve selected a sound, you can manually change the trackÕs effect bus as

you please, regardless of the setting of the AutoSelect FXBus parameter.

When you change the sound on a track in the 16 Track Recorder:

¥ with AutoSelect FXBus on, the sound you choose will be routed to its Alt. FX Bus

¥ with AutoSelect FXBus off, the track effect bus setting will remain unchanged when you select the

new sound

After youÕve changed the trackÕs sound, you can manually change the trackÕs effect

bus as you please, regardless of the setting of the AutoSelect FXBus parameter.

When you change any system setting, ZR-76 operations will pause momentarily

to store your settings into FLASH memory.

1. Press the System button.

2. Turn the Parameter knob until the display shows:

System/MIDI:

Set system prefs?

3. Press Yes if youÕd like to change the current system preferences. Press No if youÕd like to cancel the

procedure.

Other manuals for ENSONIQ ZR-76