ENSONIQ ZR-76 - Page 47

To Next Page

To Previous Page

Chapter 3ÑGlobal Settings

ENSONIQ ZR-76 Musician's Manual38

4. Turn the Parameter knob until the display shows:

System Preferences:

AutoSelect FXBus= On

The current AutoSelect FXBus value

The AutoSelect FXBus parameter can be set to:

¥ OnÑto let the ZR-76 pick the chorus or reverb bus for newly-selected sounds that have no

insert effect in SoundFinder, and for newly selected split, layer and 16 Track Recorder track

sounds

¥ OffÑto leave the effect bus assignment unchanged when a new sound is selected anywhere in

your ZR-76

5. Use the Value knob to set AutoSelect FXBus to the desired setting.

Sounds are programmed with their own optimal settings, and when you choose a sound, it brings those

settings along. As a result, the following 16 Track Recorder track parameters will be reset when you

select a new sound on a track: Pitch Bend Up, Pitch Bend Down, Octave Shift, Semitone Shift, Fine

Tuning, PtchTbl, Glide Mode, Glide Time, Delay Time, SyncLFO&Noise, Normal LFO Rates, LFO Depth,

LFO Delay Time, Amp Env Attack, Amp Env Decay, Amp Env Release, Filter Cutoff, Filt Env Attack, Filt

Env Decay, Filt Env Release and Amp&FiltEnv Vel.

You might want to choose a new sound without losing your current track settings. You can use the

system Track ParamReset parameter to determine whether or not these track parameter settings will be

retained when you select a new sound. This parameter affects 16 Track Recorder sound selection from

the ZR-76Õs front panel, as well as sound selection through the reception of MIDI Program Changes.

The system Track ParamReset parameter also affects how tracks respond to a Reset All Controllers MIDI

message. When the ResetControlRecv System parameterÑdescribed later in this chapterÑis set to On, a

number of track parameters are reset to default values when the ZR-76 receives a Reset All Controllers

message. (See ÒReceiving Reset All Controllers MIDI MessagesÓ later in this chapter.) Setting the Track

Param Reset to Off will protect the settings of the track parameters listed above from Reset All Controllers

MIDI messages.

When you change any system setting, ZR-76 operations will pause momentarily

to store your settings into FLASH memory.

1. Press the System button.

2. Turn the Parameter knob until the display shows:

System/MIDI:

Set system prefs?

3. Press Yes if youÕd like to change the current system preferences. Press No if youÕd like to cancel the

procedure.

Other manuals for ENSONIQ ZR-76