ENSONIQ ZR-76 - Page 51

To Next Page

To Previous Page

Chapter 3ÑGlobal Settings

ENSONIQ ZR-76 Musician's Manual42

1. Press the System button.

2. Turn the Parameter knob until the display shows:

System/MIDI:

Alter system pitch?

3. Press Yes if youÕd like to change the system pitch settings, or No to cancel the procedure.

4. Turn the Parameter knob until the display shows:

System Pitch:

Pitch Bend Up= 2up

The current Pitch Bend Up value

The global Pitch Bend Up parameter can be set to:

¥ 1-12dn or 1-12upÑthe pitch of sounds whose Pitch Bend Up=Sys will be lowered or raised by

the number of equal-temper semitones set here when the pitch bend wheel is pushed all the way

forward.

¥ OffÑsounds whose Pitch Bend Up=Sys will not change pitch when the pitch bend wheel is

pushed forward.

5. Use the Value knob to set the Pitch Bend Up value you desire.

When you change any system setting, ZR-76 operations will pause momentarily

to store your settings into FLASH memory.

1. Press the System button.

2. Turn the Parameter knob until the display shows:

System/MIDI:

Alter system pitch?

3. Press Yes if youÕd like to change the current system pitch settings. Press No if youÕd like to cancel

the procedure.

Other manuals for ENSONIQ ZR-76