ENSONIQ ZR-76 - Page 50

To Next Page

To Previous Page

Chapter 3ÑGlobal Settings

ENSONIQ ZR-76 Musician's Manual 41

1. Press the System button.

2. Turn the Parameter knob until the display shows:

System/MIDI:

Set system prefs?

3. Press Yes if you'd like to change the current system preferences. Press No if you'd like to cancel the

procedure.

4. Turn the Parameter knob until the display shows:

System Preferences:

Rewind Sound= On

The current Rewind Sound value

The Rewind Sound parameter may be set to:

¥ OnÑpressing the 16 Track Recorder Rewind button will play the rewind sound.

¥ OffÑpressing the 16 Track Recorder Rewind button will not play the rewind sound.

5. Use the Value knob to set Rewind Sound to the desired setting.

The pitch bend wheel is the spring-loaded wheel located to the far left of the keyboard. ItÕs most

commonly used to bend the pitch of notes up or down by pushing the wheel forward (up) or pulling it

back (down).

Most ZR-76 sounds are programmed to respond to Pitch Bend messages in ways appropriate to the

purpose of the sound. The ZR also offers a global pitch bend setup, which is always available to any

sound. By setting the soundÕs pitch bend up and down parameters to ÒSys,Ó you can instruct a sound to

use the global pitch bend settings instead of its own programmed settings. (See Chapter 4 for details.)

The ZR-76 offers three parameters for controlling the global pitch bend:

¥ Pitch Bend Up

¥ Pitch Bend Down

¥ PitchBendMode

Both pitch bend up and pitch bend down have their own individual settings, and either can be set to

raise or lower the pitch of any sound. This parameter affects any sound whose Pitch Bend Up or Down

parameter is set to ÒSys.Ó

When you change any system setting, ZR-76 operations will pause momentarily

to store your settings into FLASH memory.

Other manuals for ENSONIQ ZR-76