ENSONIQ ZR-76 - Page 55

Chapter 3ÑGlobal Settings
ENSONIQ ZR-76 Musician's Manual46
PitchTbl can be set to:
¥ ProgÑto use the PitchTbl value programmed into the sound
¥ SysÑto use the global system pitch table
¥ the special pitch tables built into the ZRÕs memory
3. Turn the Value knob to set PitchTbl to Sys.
NN
NN
oo
oo
tt
tt
ee
ee
::
::
When you select a new sound, PitchTbl will be reset to Prog. This can be prevented
in the 16 Track Recorder by setting the System Track ParamReset parameter to Off. The
Track ParamReset parameter is described earlier in this chapter.
This parameter also responds to an NRPN LSB value of 021. To learn what an NRPN, and what it would
be used for, see ÒUsing RPNs and NRPNs to Edit Sound ParametersÓ at the end of Chapter 4.
For a complete list of pitch tables and their descriptions, see Chapter 13Ñ Supplemental Information.
SS
SS
ee
ee
tt
tt
tt
tt
ii
ii
nn
nn
gg
gg
UU
UU
pp
pp
FF
FF
oo
oo
oo
oo
tt
tt
SS
SS
ww
ww
ii
ii
tt
tt
cc
cc
hh
hh
ee
ee
ss
ss
UU
UU
ss
ss
ii
ii
nn
nn
gg
gg
FF
FF
oo
oo
oo
oo
tt
tt
SS
SS
ww
ww
ii
ii
tt
tt
cc
cc
hh
hh
ee
ee
ss
ss
The ZR-76 is equipped with two stereo foot switch jacks, located on its rear panel:
These two independent foot switch jacks support either a single (mono) or dual (stereo) foot switch, and
can be assigned to a number of different functions, allowing a total of four independent foot switch
controllers when two optional ENSONIQ SW-10 Dual Foot Switches are connected.