Chapter 3ÑGlobal Settings
ENSONIQ ZR-76 Musician's Manual 47
There are four parameters that let you assign the foot switches to a variety of functions. When a single
foot switch is connected, set the FtSw 1L parameter described below to ÒUnused.Ó
WW
WW
aa
aa
rr
rr
nn
nn
ii
ii
nn
nn
gg
gg
::
::
If you are using a single foot switch (ENSONIQ SW-2 or SW-6) in either of the
Foot Switch jacks, the FtSw 1L and/or FtSw 2L values on the system page should always
be set to ÒUnused.Ó The foot switch jacks are optimized for use with a stereo foot switch
(such as ENSONIQÕs SW-10 foot switch), and when a single foot switch is connected, it
operates as the right foot switch.
For more information about using mono and stereo foot switches with the ZR-76, see Chapter 13Ñ
Supplemental Information.
When you change any system setting, ZR-76 operations will pause momentarily
to store your settings into FLASH memory.
TT
TT
oo
oo
AA
AA
ss
ss
ss
ss
ii
ii
gg
gg
nn
nn
aa
aa
FF
FF
uu
uu
nn
nn
cc
cc
tt
tt
ii
ii
oo
oo
nn
nn
tt
tt
oo
oo
aa
aa
FF
FF
oo
oo
oo
oo
tt
tt
SS
SS
ww
ww
ii
ii
tt
tt
cc
cc
hh
hh
1. Press the System button.
2. Turn the Parameter knob until the display shows:
System/MIDI:
Set up foot control?
3. Press Yes if youÕd like to change the current foot switch settings. Press No if youÕd like to cancel the
procedure.
There are four foot switch parameters, each of which represents one of the four available foot switch
pedals:
¥ FtSw 1LÑthe left pedal of foot switch 1
¥ FtSw 1RÑthe right pedal of foot switch 1
¥ FtSw 2LÑthe left pedal of foot switch 2
¥ FtSw 2RÑthe right pedal of foot switch 2
Each foot switch pedal can be set to perform a specified function when pressed:
¥ UnusedÑpressing the pedal will have no effect.
¥ SustainÑholding the pedal will cause notes to continue sounding after the key is released, much
like the sustain pedal on a piano.
To Next Page
Loading...
