Luna Series |
CACT-DSC-800L
www.enviosecurity.com
CA
CT-DSC-500
ST
8MP DSC PIR DETECTOR WITH AUDIO
Technical Specification Camera
1/3”CMOS Sensor
3840(H)×2160(V),8MP
3840x2160
1-channel BNC high definition video output
AHD/HD-TVI 8MP@15FPS;HD-CVI 5MP@20FPS
Multi-language
Technical Specification Pir Detector
Detection method
Voltage
Temperature compensation
Alarm Duration
Quad Pyroelectric Sensor (four elements)
8.2 to 16 Vdc
Monochrome: 115 mA Color: 150 mA Yes
2 ±1 s
N.C 28 Vdc 0.1 A with 10 Ohm series resistor
open when cover is removed
1 min
Red LED on during alarm
More than
10 V/m, 80% AM from 80 MHz to 1GHz
Immunity to Pulses
Operating temperature
Dimensions
10 ºC a +50 ºC
• 4K Lite 1/3”CMOS Sensor
• 8 Megapixel (3480x2160)
• 4in1 AHD,HD-CVI, HD-TVI, CVBS (UTC)
• 3.7mm
Fixed Lens
• Audio Out with Build in Microphone
• 4in1 AHD,HD-CVI,HD-TVI,CVBS (UTC)
• IP20
• DC12V
• Pets Immunity
• 15mt Detection Area
Analog High Definition PIR Detector
Dear Customer, we thank you for choosing one of our products whose correct use
guarantees solutions of the highest quality and reliability over time. This manual
provides instructions for using the product.
Make sure the camera is not powered before making connections.
The video cable is connected to the female bayonet BNC connector, which is then
taken to the monitor or DVR in general via RG59 type coaxial cable and BNC
connector. Twisted pair cables can also be used with balun converters.
Check that the power supply is correct and provided for the camera model used.
The use of adequate power supply units is recommended. 12Vdc / 1A or 12Vdc /
1,5A stabilized is recommended. The pin required is the standard 5.5 mm. Beware
of power extension cables that are too long or have a small section, which could
introduce an excessive voltage drop, especially when the IR illuminator is turned on.
The values expressed in the following table are to be considered at a temperature
of 20 ° C [68 ° F].
Choice of location for mounting. Select the most suitable location to detect the
presence of an intruder. (Corner installation is recommended). See coverage area
(Fig. 3).
The highly sensitive four-element sensor
detects the movements that cross the
beams; it is slightly less sensitive at
detecting movement towards the
detector. Avoid the following locations:
Exposure to sunlight. Facing areas that
can change temperature rapidly. *
Locations with air ducts or strong air
currents. The detector performance is
optimal in a uniform and stable
environment.
The detector must be installed and used
in environments with a pollution degree
not exceeding factor 2 and overvoltage
category II, IN NON-HAZARDOUS
ENVIRONMENTS, indoors only. The
detector is designed to be installed by
To Next Page
Need help?
General
