Environmental Water Systems EWS-1054 User Manual

EWS, Inc. / Environmental Water Systems
www.EWSWATER.com
4.4-1
Care and Use Manual
Tank Series Appliances
Information Provided for the Proper Set-Up, Installation and
Start-Up of the following Appliances:
 EWS Series of Whole Home Filtration and Physical Conditioning:
EWS-1054, EWS-1354, EWS-1354-HF, EWS1354-11/2”
 CWL Series of Whole Home Filtration:
CWL-1035 LTD, CWL-1054, CWL-1354, CWL-1354-HF, CWL-1354-11/2”
 Iron Removal Series:
EWS-1054-P, EWS-1354-11/2”-P
To the Installer: Please Read and Leave this Owner’s Manual with the Unit or the Consumer
To the Consumer: Retain this Care & Use Manual for Product Registration and Future Reference
ALL PRODUCT PROUDLY MANUFACTURED AND ASSEMBLED IN THE USA

Environmental Water Systems EWS-1054 Specifications

General

Brand	Environmental Water Systems
Model	EWS-1054
Category	Water Filtration Systems
Language	English

Summary

Plumbing and Drain Connections

Connecting Water Supply and Drain

Instructions for plumbing inlet, outlet, bypass valve, and drain port connections.

Plumbing and Drain Connections for HF/Iron Models

Connecting Supply and Drain for HF/Iron Units

Instructions for plumbing connections specific to HF and Iron Removal units.

Plumbing and Drain Connections for 1 1/2-Inch Models

Connecting Supply and Drain for 1 1/2-Inch Units

Instructions for plumbing connections specific to 1 1/2-inch inlet/outlet units.

Start-Up Procedure for All Units

Importance of Proper Start-Up

Emphasizes correct start-up to prevent issues and voiding warranty.

Step 1: Fill Tank Slowly

Instructions for the initial slow filling of the tank with water.

Step 1-A: Partially Open Inlet

Completing Tank Fill and Initial Setup

Open Inlet Completely

Plug in Electrical Component

Details on connecting the unit's electrical transformer to an outlet.

Set Time of Day

Backwashing and Flushing the System

Purpose of Backwash and Flush

Explains the goal of removing media dust and preparing the system for use.

Step 4-A: Perform Backwash Cycle

Detailed instructions on initiating and monitoring the backwash cycle.

Step 4-B: Perform Settling Cycle

Final Flushing and Service Preparation

Step 4-C: Rapid Rinse Cycle

Step 5: Place Unit in Service Position

Step 6: Flush Pipes and Heaters

On-Site Assembly Procedures

Assembly Steps for Tank and Riser