Envirosight VISIONCONTROL VC500 User Manual

Measurement tools
Overview of the Measuring Functions
59
Overview of the Measuring Functions
You can perform the following measurements using the VISIONREPORT II inspection software:
/GCUWTKPIETCEMU
You can measure cracks here using the camera’s integral laser. The camera laser only serves as a reference. The measurement is performed by
touching the measurement points after the laser calibration.
/GCUWTKPIETQUUUGEVKQPQDLGEVU
You can measure the objects which are located on the cross-section of a pipe, e.g. roots, object in pipe.
/GCUWTKPIRKRGDGPFU
You can measure angle of a bend here.
/GCUWTKPIDTCPEJFKCOGVGTU
You can measure the diameter of a branch here.
2QKPVNCUGTFKCOGVGTOGCUWTGOGPV
You can measure the diameter of the pipe with the help of the camera lasers (only possible with RCX90, PTP70 II, PTP50 and PTC50)
RQKPVNCUGTFKCOGVGTOGCUWTGOGPV
You can measure the diameter of the pipe with the help of the camera lasers (only possible with PTP70 II and PTP50 and the AGILIOS push
camera system)
2WUJUVKEMFKCOGVGTOGCUWTGOGPV
You can measure the diameter of the pipe with the help of the push stick attached to the camera head (only possible with PTP70 III and PTP50) .
/GCUWTKPIDTCPEJCPINGU
You can measure the angle of a brancht in the pipe here.
/GCUWTKPIVJGYCVGTNGXGN
You can measure the level of the water in the pipe here.
2QUKVKQPFGVGTOKPCVKQPQHFCOCIGU
;QWECPFGƂPGVJGRQUKVKQPENQEMQHFCOCIGUKPCTWPPKPIKPURGEVKQP
+PENKPCVKQPOGCUWTGOGPV
You can measure the inclination of the pipe during the course of the crawler movement.

Envirosight VISIONCONTROL VC500 Specifications

General

Brand	Envirosight
Model	VISIONCONTROL VC500
Category	Controller
Language	English