energiSava
®
200
01423 810 810
SHOULD YOU ENCOUNTER ANY PROBLEMS
INSTALLING THIS UNIT, CALL US ON:
1 2
Installation - Floor Unit
1. Hold the unit in the chosen location and check there is space
for ducts, condensate drainage, filter and keypad access.
2. Screw the four mounting brackets to the unit as shown using
the screws provided. The two larger brackets are fitted at the
spigot end.
3. Remove the green plug from the black drain at the bottom of
the unit. Now insert the green plug fully into the white drain above.
4. Screw all four brackets to the mounting surface then make
a water-tight connection between the black drainage connector
on the unit and the waste water system in the property with a
minimum five degree fall and an appropriate non-return device
fitted (see spares/accessories table later in this guide).
9
To Next Page
Loading...
