Envirovent energiSava 200 Installation Guide

energiSava
®
200
01423 810 810
SHOULD YOU ENCOUNTER ANY PROBLEMS
INSTALLING THIS UNIT, CALL US ON:
Safety
Read and understand these instructions carefully before
beginning installation. The unit should only be installed by a
competent person.
Electrical Connection
The unit requires a continuous electrical power supply. Connection to
the fixed wiring must be made outside the unit in a suitable location.
The unit must be able to be disconnected from the mains supply
after installation. The unit must be earthed and a double pole switch
having a minimum contact separation of 3.0mm must be used to
provide isolation for the unit.
The power cable running into the unit must remain the supplied
flexible cable (not a solid core lighting cable]. If the power cable
becomes damaged, it must be replaced by EnviroVent, an authorised
service agent for your region/country, or a similarly qualified person in
order to avoid a hazard. Do not remove or tamper with any electronic
components inside the unit.
All wiring must comply with Building Regulations and the current
IET Wiring Regulations (BS7671 in the UK) or equivalent standards for
other countries. The final installation should be examined and tested
by a qualified electrician.
This product is not suitable for use with a Type AC RCD
1

Envirovent energiSava 200 Specifications

General

Brand	Envirovent
Model	energiSava 200
Category	Heating System
Language	English