Envirovent energiSava 200 User Manual

FOR ADDITIONAL INFORMATION, SEE THE INSTALLATION GUIDE
Warranty
The EnviroVent energiSava
®
200 is covered by a
full 2-year warranty. You will find the terms of the
warranty in the installation guide.
• DO NOT switch off the unit - The unit is set to
run continuously 24 hours a day, 7 days a week.
• DO NOT adjust the ceiling valves - The valves
are set to allow a certain amount of air through
and should not be adjusted.
Maintenance
Recommended maintenance schedule:
The following checks are recommended to ensure
that this heat recovery system operates at its
optimum level.
Yearly maintenance and checks - To be carried
out by the user or maintenance company.
• Check there is sufficient airflow coming
through the diffusers.
• Change filters x 2 (see illustration below)
• Call EnviroVent on 01423 810 810 -
Filter part code is FILTER-ES250
Service
The unit should be serviced every 2 years by
EnviroVent, a maintenance company or other
competent person. This would include filter
replacements, air flow and a condense drain check.
Any worn out components can then be exchanged.
These would then be brought back to the Harrogate
factory to be recycled.
Safety
You do not need to remove the covers from the unit,
any repair work should be carried out by a qualified
person to avoid hazard. If the supply cord is
damaged, it must be replaced by the manufacturer,
service agent or similarly qualified person.
Emergency shutdown details - Unit to be
isolated from the mains by turning it off at
the isolating switch.
Filter
cover
Filters x 2 Part number
FILTER-ES250
Control
switch
Screws
Front cover

Envirovent energiSava 200 Specifications

General

Brand	Envirovent
Model	energiSava 200
Category	Heating System
Language	English