© EnvisionTEC Page 3 of 3
TS-OPI-PWA-2000-V20200219-FN-EN.pdf
Safety Instructions
Warning: The PWA 2000 removes uncured resin from
the surface of 3D printed models using chemicals such
as 99% isopropyl alcohol and PC1. The PWA 2000 is
a professional product and must be used by qualied
personnel, following safety instructions.
Warning: The PWA 2000 is powered at US - 110V
/ EU - 220V mains voltage. Avoid tampering with
the equipment and all of its parts to avoid risk of
electrocution. In case of malfunction of the device
contact EnvisionTEC technical support or an authorized
distributor.
Warning: It is recommended that the user carefully
read the instructions for the cleaning product used for
cleaning the 3D printed models before operating the
PWA 2000 in conjunction with this product.
Warning: Always operate the PWA 2000 in well
ventilated areas. Many cleaning products are ammable
and highly volatile. After use place the cleaning products
in their appropriate storage containers. Do not use the
PWA 2000 near sources of heat or sparking.
Warning: After use, always empty the cleaning product
from the washing compartment. Be careful when
emptying the washing compartment.
Copyright
This instruction manual must be treated condentially. It should
only be used by authorized personnel. It may only be entrusted or
made available to third parties with the prior written consent of
EnvisionTEC GmbH, EnvisionTEC Inc. or authorized distributors.
All documents are protected within the sense of copyright law.
No part of this documentation may be reproduced, utilized or
transmitted without specic prior consent. Infringements are
an oence resulting in obligatory compensatory damages.
All industrial rights reserved.
Trademark
EnvisionTEC® and Perfactory® are related product names that are
registered Trademarks of EnvisionTEC GmbH, Germany.
Manufacturer Warranty
This instruction manual must be read carefully before installing the
product and putting it into operation. We assume no liability for damage
and malfunctions resulting from failure to comply with the instruction
manual. Furthermore, no warranty can be provided for faults that are
due to subjecting the goods to improper use or application above
average strain, nor can any warranty be provided for wearing parts.
In case any material defects or errors occur despite correct usage,
EnvisionTEC oers a warranty period limited to one year starting from
the moment the customer is supplied with the goods for the 3D printing
system and respective accessories. The obligation of EnvisionTEC
is limited to repairing or replacing defective machine parts.
Under no circumstances will EnvisionTEC assume liability for
the consequences or side eects of a violation of warranty
conditions, even if this has been agreed to or expected, and
even in case of fault or negligence on the part of the company.
EnvisionTEC expressly refrains from granting any other warranty
claims in this respect. Neither representatives/dealers nor employees
of the company are authorized to increase or alter the warranty
claims. Contact EnvisionTEC for more information regarding Warranty
Programs and for details about extended warranty options.
To Previous Page
Loading...