Need help?Do you have a question about the Enwa MT 1500 and is the answer not in the manual?
General| Brand | Enwa |
|---|---|
| Model | MT 1500 |
| Category | Water Filtration Systems |
| Language | English |
Details the reverse osmosis desalination stage using high pressure.
Instructions for shutting down the unit for extended periods.
Warning against using specific conservation solutions.
Warning regarding the handling of MT-5 chemical compound.
Details the steps for chemical treatment of the unit.
Instructions on preparing the chemical treatment solution.
Close the valve upstream the mesh filter.
Close the flush water valve.
Close the feedwater valve.
Fully open the pressure-regulating valve.
Do not start the feedwater pump.
Start the high-pressure pump (HPP-2010) manually.
Re-circulate the cleaning solution for at least one hour.
Stop the high-pressure pump (HPP-2010).
Flush the unit with water after cleaning.
Reconnect hoses and start unit if it's to be in service.
Warning about initial start-up after shutdown or cleaning.
Details on using MT-10 for general cleaning or pre-cleaning.
Instructions for preparing the MT-10 cleaning solution.
Procedure for sterilisation when bacteria content is high.
Procedure for preserving the unit for more than 1 week.
Details on using MT-20 for scaling or metal-oxide fouling.
Solutions for low feedwater pressure issues.
Troubleshooting steps for zero operation pressure.
Steps to diagnose why the high-pressure pump won't start.
Solutions for the high-pressure pump stopping shortly after starting.
Steps to address reduced product flow.
Actions to take when a high conductivity alarm occurs.
Guidelines for changing the feedwater filter.
Instructions for replacing the flush water filter.
Procedure for lubricating the high-pressure pump.
How to adjust the V-belt tension.
Procedure for controlling the safety valve's opening pressure.
To Next Page
