11
INSTALLATION GUIDE
Remove all the Surface Lids.
Note: Set aside hardware as it will be used again.
Attach the Mini CPU Bracket to the underside of
the Shelf using the provided #8 x ¾” Pan Head
Phillips screws.
Note: There are pilot holes to locate position. You
may need to raise the Lifting Column to access
the holes.
With the actuator fully raised, attach your mini CPU
to the bracket with either 2 methods:
• Bolt your mini CPU to the Mini CPU Bracket
utilizing the standard Vesa hole pattern. Bolts are
NOT provided by Enwork.
• Zip tie the CPU utilizing the slots in the Mini CPU
Bracket. Zip ties are NOT provided by Enwork.
FIGURE 6.1
FIGURE 6.2
FIGURE 6.3
6) ASSEMBLY: ACCESSORIES – MINI CPU
To Next Page
Loading...
