46
EN Electrical installation
6. Electrical installation
6.1 General instructions for electrical installation
Inappropriate installation or usage could cause re hazard! Please read this mounting
instructions carefully. Pay attention to all measurement specications and the following
notes.
The mill wheel must only be used in connection with the sauna heating device EOS Her-
kules S60 or EOS Stone S60 9,12 oder 15 kW and the associated sauna control unit.
The device has been designed for a connection voltage of 230 V AC.
The installation and the connection of the device and other electrical utilities must only be
carried out by trained technicians. Here, it is especially important to abide by all protective
measures necessary according to VDE 0100v. §49DA/6 and VDE 0100 Part 703/2006-2
The mill-sauna will be connected to the power supply system via an earthed plug. All
connecting lines to be passed inside the cabin must be suitable for an ambient tempera-
ture of min 140 degree. We recommend a silicone line. If single-wired lines will be used as
connecting lines, they must be protected by bendable metal pipes
Please see that the control unit is located outside the cabin.
The electrical installation must be performed by authorised electricians only.
The provisions of your public utility and the relevant VDE provisions (DIN VDE 0100) must be ob-
served.
Beware, danger of life: Never perform repairs and installations yourself. The housing must only be
removed by an expert.
All wires of the system must be dis connected from the mains during installations and repairs, i.e.
fuses or main switches must be deactivated.
The security and installation notes of the sauna oven manufacturer must be observed.
To Next Page
Loading...