54
EN Maintenance
8. Maintenance
2-2,5 mm
2-2,5 mm
► Adjusting the drivebelt tension
First loosen the four mounting screws
(B).
Adjust the drivebelt tension using the
adjustment screw (A).
NOTICE! The drivebelt may be compressed by a
maximum of 5 mm under light pressure.
Finally, tighten again the four adjust-
ment screws (B) of the motor.
The Watermill wheel, blades and cascade
must be cleaned of limescale residues at
least once a week.
A. Adjustment screw
B. Mounting screws
A
B
Motor with drivebelt
To Next Page
Loading...