Need help?Do you have a question about the Epifani UL501 and is the answer not in the manual?
1/4" TS phone jack for connecting your instrument using a shielded cable.
Reduces input signal by -10 dB for active electronics or high-output pickups. Includes Peak LED.
Preamp gain control adjusts input signal level. Set for optimum input level with Peak LED flashing red intermittently.
Active shelving control to adjust low frequencies.
Active bandpass control to adjust midrange frequencies.
Active shelving control to adjust high frequencies.
Sets the Treble control apex to 3 kHz (pushed in) or 6 kHz (out).
Activates the Mid Cut circuit when pushed in; can also be foot-switch controlled.
Adjusts the amount of mids cut when turned counter-clockwise.
Mutes all outputs except Tuner Out. LED glows red when muted; active upon startup.
Adjusts the Speaker Output level. Other outputs are unaffected. Power LED glows blue when on.
Turns the amplifier on/off. Features a 3-second delay for self-diagnostic.
Port for plugging in the included IEC compliant AC power cable.
Contains the fuse. Contact Epifani if the fuse blows.
Neutrik Speakon/1/4" Phone Jack Combo connector for speaker connection. Min impedance 4 Ohms.
Connect an electronic tuner. Sends signal when muted for silent tuning.
TRS Phone connector for optional two-button foot-switch (Mute/Mid Cut).
Send/Return jacks for connecting external signal processors.
Blends dry and effected signals from the Effects Loop.
Sets the DI Output signal to either pre-EQ or post-EQ.
Disconnects chassis ground from DI Out to reduce 60-cycle hum.
Balanced, low impedance output via XLR for connecting to consoles or recording devices.
Adjusts the output level of the DI output.
Set Master to zero, connect AC, turn on. Amplifier performs self-diagnostic and engages Mute.
Set instrument volume high, EQ flat. Increase Gain until Peak LED flashes red, then back off slightly.
Disengage Mute, then turn Master Volume clockwise to desired listening level.
Use EQ controls subtly. Cutting frequencies often yields better results than boosting.
The Mid Cut feature reduces mid-range frequencies, offering an additional level of tonal control.
Consider how room acoustics and speaker placement affect sound; use EQ to adapt.
Adjust Gain for optimal input level, ensuring the Peak LED flashes red only intermittently.
Adjust EQ carefully to avoid distortion, especially with active basses, by balancing gain and frequency boosts.
General| Brand | Epifani |
|---|---|
| Model | UL501 |
| Category | Musical Instrument Amplifier |
| Language | English |
To Next Page