Start Here
4 Slide the edge guides against the paper, but not too
tight. Make sure the paper is under the tabs on the edge
guides.
Letter
5 Lower the photo tray.
6 Squeeze the edge guides and slide them out. Then
insert 4 6-inch or 5 7-inch photo paper with the
glossy or printable side facedown.
Note: Make sure the paper fits under the edge guides.
7 Slide the edge guides against the paper.
4 6 in
(102 152 mm)
8 Keep the cassette flat as you insert it.
9 Extend the output tray and flip up the paper stopper.
Note: Do not flip up the paper stopper if you’re using legal-size
paper.
Read these instructions before using your product.
1
Unpack
French control panel stickers
(for Canada only)
Caution: Do not open ink cartridge packages until you are ready to
install the ink. Cartridges are vacuum packed to maintain reliability.
Remove all protective materials from the printer, including
from inside the paper cassette.
1 Raise the scanner unit and remove the transportation lock.
Store the transportation lock as shown.
2 Lower the scanner unit.
2
Turn on and adjust
1 Connect the power cord to the back of the printer and to
an electrical outlet.
Caution: Do not connect to your computer yet.
2 Press the On button, then adjust the control panel.
3
Select language
Press or to select your language, then press OK.
Note: You can change the language using the product’s control
panel. For more information, see the online User’s Guide.
4
Install ink cartridges
1 Lift up the scanner unit.
2 Unpack the ink cartridges.
3 Remove only the yellow tape from each cartridge.
Caution: Don’t remove any other seals or the cartridges may
leak.
4 Insert the cartridges in the holder for each color. Press
each cartridge down until it clicks.
5 Lower the scanner unit.
6 Wait while the printer is priming, which takes about
7 minutes.
Note: Your printer ships with full cartridges and part of the
ink from the first cartridges is used for priming the printer.
Replacement cartridges will print more pages.
Caution: Don’t turn off the printer while it is priming or you’ll
waste ink.
7 When you see this menu
on your product’s LCD
screen, do not make a
selection yet. Continue
with the instructions in the
following sections to load
paper in your product and
install software.
5
Load paper
The paper cassette has 2 trays. The main tray is for
letter-size, A4, legal-size, or 8 10-inch paper. The photo
tray is for 4 6- or 5 7-inch photo paper. For instructions
on loading legal-size paper, see the online User’s Guide.
1 Open the front cover (if it’s not open already).
2 Pull out the paper cassette at the bottom of the printer.
Then slide back the photo tray and lift it up.
3 Squeeze the edge guides and slide them out. Then insert
paper with the glossy or printable side facedown.
Artisan
®
730
To Next Page
Need help?
General
Weight and Dimensions
