f
Repeat procedures 4 and 5 as needed to adjust any remaining
corners.
g
When you are done, press the [Esc] button to exit the correction
menu.
Because Keystone was changed to Quick Corner, the corner
selection screen shown in step 4 is displayed the next time you press
the [
w] or [v] button on the control panel. Change Keystone to
H/V-Keystone if you want to perform horizontal and vertical
correction using the [
w] or [v] button on the control panel.
s Settings - Keystone - H/V-Keystone p.94
a
If the [Esc] button is held down for about two seconds while
the corner selection screen from step 4 is displayed, the
following screen is displayed.
Reset Quick Corner: Resets the result of Quick Corner
corrections.
Switch to H/V-Keystone: Switches the correction method to
H/V-Keystone.
s "Settings Menu" p.94
Automatically adjust to fit into the screen frame -
Screen Fit
Screen Fit is a function that corrects the projected image so that it fits to
the frame (border) of the screen, whiteboard, and so on. When you press
the [Screen Fit] button on the remote control or control panel, the
projected image is adjusted to fit the frame of the screen while also
performing keystone correction.
Adjusting Projected Images
42
To Next Page
Loading...
