16
(2) Insert the slide plate into the setting plate from the interface side of the projector (A).
Align the marks on the projector and the setting plate (
B).
(3) Tighten the two M5 x 12 mm hexagon socket head cap bolts (
C).
E Connect the power cable and other cables to the projector
Connect any necessary cables such as the power cable, computer cable, and USB cable to the projector.
Projector
interface side
M5 x 12 mm hexagon
socket head cap bolts (2)
Marks
Bolt positions
Slide plate
If you use adhesives to prevent the screws from loosening or things such as lubricants or oils
on the slide plate fixing part of the projector, the case may crack and cause the projector to fall,
resulting in personal injury or property damage. Do not use adhesives, lubricants, or oils to
install or adjust the setting plate.
Power cable
Computer cable
USB cable
To Next Page
Loading...
