Appendix
63
Copying saved settings to other projectors
a
Disconnect the power cord from the projector, and check that all of the projector's
indicators have turned off
b
Connect the computer's USB port to the projector's USB-B port with a USB cable
c
While holding down the [Menu] button on the remote control or the control panel, connect
the power cord to the projector
The status indicator and the power indicator turn blue, and the lamp indicator and the temperature
indicator turn orange.
When all of the projector's indicators turn on, release the [Menu] button.
The projector is recognized as a removable disk by the computer.
d
Copy the batch setup file (PJCONFDATA.bin) that you saved to your computer to the top-
level folder of the removable disk
c
Do not copy any files or folders other than the batch setup file to the removable disk.
To Next Page
Loading...
Need help?
General
