Category Item Status Display Explanation
Status Information Source HDMI Displays the source name for the connected equipment currently being projected.
HDBaseT
DVI-D
SDI
Computer
BNC
LAN
On-Screen Display On Displays the settings for the On-Screen Display. When set to Off, the menus or messages are
not displayed on the projected images.
Off
A/V Mute On Displays the operating status of A/V mute.
Off
Air Temp − Displays the usage environment temperature.
Temp Level −
AC Voltage Monitors the status of the input voltage, and displays the current voltage.
Example:
175V: Indicates that the voltage is 175V.
B50V: Indicates that the voltage is 50V or less.
---V: Indicates that the voltage logs cannot be measured.
Check the following if logs are not displayed correctly.
s
"Detailed logs and error message are not displayed" p.205
<Warning1> Voltage drop: If the input voltage drops below 89 V for more than 1,000 msec, logs for
approximately one second* before and after the event (120 logs) are displayed.
* The number of seconds varies according to the power supply frequency (50 Hz/60 Hz).
<Warning2> Power flicker: If the input voltage drops below 85 V for more than 40 msec, and the voltage
returns within 60 msec, logs for approximately one second before the power flicker was detected
(60 logs) and for approximately 0.1 seconds after (6 logs) are displayed.
Reading the Status Display
188
To Next Page
Loading...
