132
Replacing the Remote Control Batteries
The remote control uses two AA manganese or alkaline batteries. Replace the
batteries as soon as they run out.
Warning
Check the positions of the (+) and (–) marks inside the battery holder to
ensure the batteries are inserted the correct way. If the batteries are not used
Attention
correctly, they could explode or leak causing a fire, injury, or damage to the
Make sure you read the Safety Instructions before handling the batteries.
product.
a
Open the battery cover as shown.
d
Close the battery cover and press it down until it clicks into place.
b
Remove the old batteries.
c
Insert the batteries with the + and – ends facing as shown.
To Next Page
Loading...
Need help?
General
