Installing Batteries in the Remote Control
35
The remote control uses the two AA batteries that came with the projector.
Attention
Make
sure you read the safety instructions in the online Notices before handling
the batteries.
a
Remove the battery cover as shown.
b
Remove the old batteries, if necessary.
a
Dispose of used batteries according to local regulations.
c
Insert the batteries with the + and – ends facing as shown.
Warning
Check the positions of the (+) and (–) marks inside the battery holder to
ensure the batteries are inserted the correct way. If the batteries are not used
correctly, they could explode or leak causing a fire, injury, or damage to the
product.
d
Replace the battery cover and press it down until it clicks into place.
To Next Page
Loading...
Need help?
General
