Epson ELPDC07 - Safety Standards Symbols

The following table describes the safety symbols displayed on the product.
No. Symbol Supported
Standard
Explanation
A
IEC60417
No.5007
Power ON
Indicates connection to power supply.
B
IEC60417
No.5008
Power OFF
Indicates disconnection from power
supply.
C
IEC60417
No.5009
Standing by
Indicates electricity is being supplied to
part of the device/equipment when the
switch or position of the device/
equipment is in standby status.
D
ISO7000
No.0434B
IEC3864-B3.1
Caution
Indicates caution must be taken when
handling the product.
E
IEC60417
No.5041
Caution (Hot)
Indicates parts of the product that should
not be touched accidentally due to high
temperatures.
F
IEC60417
No.6042
ISO3864-B3.6
Caution (Danger of Electric Shock)
Indicates that the device/equipment
presents a risk of electric shock.
G
IEC60417
No.5957
Indoor Use Only
Indicates that the device/equipment is for
indoor use only.
H
IEC60417
No.5926
Power Connector Polarity
Indicates the positive and negative
electrodes for DC power devices that can
be connected.
I
IEC60417
No.5001B
Batteries (General)
Indicates that batteries are used to power
the device/equipment. Displayed on the
battery case cover or connection port.
No. Symbol Supported
Standard
Explanation
J
IEC60417
No.5002
Battery Direction
Indicates the direction of the batteries on
the outside or inside of the battery case.
K
IEC60417
No.5019
Protective Grounding
Indicates an external conductor to
safeguard against electric shocks if a
malfunction occurs by using a connection
port or grounding safeguard port.
L
IEC60417
No.5017
Grounding
Indicates a grounding port when No. 11 is
not explicitly called for.
M
IEC60417
No.5032
AC Current
Indicates the device/equipment uses a
dedicated AC current, and has an AC
current supported port.
N
IEC60417
No.5031
Direct Current
Indicates the device/equipment uses a
dedicated DC current, and has a DC
current supported port.
O
IEC60417
No.5172
Class II Equipment
Indicates the device/equipment meets the
JIS C 9335-1/JIS C 8105-1 safety
requirements for Class II equipment.
P
ISO 3864 General Prohibition
Indicates unidentified general prohibited
items.
Q
ISO 3864 Do Not Touch
Indicates that touching specific parts of
the equipment is prohibited since an
injury could occur.
R
--- Indicates that you should not look into the
projector's lens while it is projecting.
Symbols Indicating the Device Meets the IEC60950-1 A2 Safety Standards
30