Start Here
11 Raise the control panel and turn on the product. Wait for
the power light to stop flashing, then follow step 12 to
continue ink charging.
Note: If all the product lights are flashing, turn off the product
and check that no protective material has been left inside
the product.
Caution: Do not lower the control panel without first squeezing
the release bar underneath or you may damage the product.
12 Press and hold the button for 3 seconds until
the power light starts flashing, to begin charging the
ink. Ink charging takes approximately 20 minutes. Ink
charging is complete when the power light stops
flashing.
20 minutes
3 seconds
Note: The ink bottles included with the printer are designed
for printer setup and not for resale. After some ink is used for
charging, the rest is available for printing.
Caution: Do not turn off the product or load paper while the
product is charging or you’ll waste ink.
3
Load paper
1 Make sure the product is not charging. Then flip the
feeder guard forward, raise the paper support, and tilt it
backwards slightly.
2 Slide the edge guide to the left.
Read these instructions before using your product.
Note for Spanish speakers/Nota para hispanohablantes: Para
obtener instrucciones de configuración en español, consulte la Guía
de instalación en www.epson.com/support/et2600sp (requiere una
conexión a Internet).
1
Unpack
Note: Do not open the ink bottles until you are ready to fill the ink
tanks. The ink bottles are vacuum packed to maintain reliability. Ink
bottle design may vary.
1 Remove all protective materials from the product.
2 Lift up the scanner unit and remove all protective materials
from inside the product.
Caution: Do not touch the flat white cable or the ink tubes and
their translucent cover.
3 Lower the scanner unit.
2
Fill ink tanks
Note: This product requires careful handling of ink. Wear disposable
gloves and place a sheet of paper or plastic under the ink tank when
you fill or refill the ink tanks, as ink may splatter. If ink spills, wipe it off
immediately with a damp towel to avoid permanent stains. If ink gets on
your clothes or belongings, it may not come off.
Warning: Keep the ink bottles out of the reach of children and do not
drink the ink.
1 Open the ink tank cover, then remove the cap for the black
ink tank and attach it to its holder.
2 Unpack the black ink bottle.
3 Depending on the ink bottle included with your product,
snap off the bottle tip or unscrew the lid.
4 Remove the bottle cap. Carefully remove the protective
seal (avoid touching the ink underneath the seal), then
close the bottle cap tightly.
Caution: Be sure to close the bottle cap tightly, or ink may leak.
5 Fill the tank using all of the ink in the bottle.
Note: Refer to the color coded sticker on the ink tank to identify
the color of each tank.
Caution: Be sure to fill each tank with the correct ink color.
6 Carefully seal the bottle using the reverse side of the
bottle tip or screw on the lid for proper disposal.
7 Replace the ink tank cap securely.
8 Repeat the previous steps for the remaining bottles.
9 Close the ink tank cover.
10 Connect the power cord to the back of the product and to
an electrical outlet.
Caution: Do not connect to your computer yet.
ET-2600
To Next Page
Need help?
General
