SUPPORT
GOTEK
The technical specifications and performance capabilities listed herein are subject to change at any time and may not reflect actual production capabilities. Graphics One is
not responsible for any incorrect information contained herein and urges any buyer or potential buyer to test the product prior to making a purchase.
TB-15000
136-20
2. Unpacking the ink bottles (Follow the Instructions)
ET-2720 Start up Guide
How to load SubliMate™ Ink
This guide describes the procedure on how to load Inks into the printer.
1. Unpack and remove all protective materials from the product.
3.
Filling
the ink tanks.
a. Open the ink tank cover, then open the cap for the ink
tank you are going to fill
c. Put the lower part of the cap
back on the bottle and load the inks
as shown.
b. Unscrew the entire Cap. Break or
remove the Aluminum Seal
a.
Take the bottle out of the poly bag
and remove the Black Tape
To Next Page
