Start Here
You can load the following paper sizes:
• Cassette 1: 3.5 × 5-, 4 × 6-, or 5 × 7-inch photo paper
• Cassette 2: Letter-size, A4-, legal-size, or 8 × 10-inch paper
See the instructions below for loading paper.
• Rear paper feed slot: Up to 11 × 17, one sheet at a time
See the online User’s Guide for instructions on loading paper
in cassette 1 and rear paper slot, available paper types, sizes,
loading capacity, and loading CD/DVD/Blu-ray
™
discs.
1
Lower the front cover (if it’s not open already) and pull on
the front cover to pull out the paper cassette.
2
Slide the side edge guides outward and set the front edge
guide to the paper size you are using.
3
Insert the paper with the glossy or printable side
facedown.
Note: Make sure the paper is loaded against the front edge
guide and not sticking out from the end of the cassette.
4
Slide the side edge guides against the paper, but not too
tight. Make sure the paper is under the tabs on the side
edge guides.
5
Keep the cassette flat as you insert it all the way.
6
Select the paper settings on the product’s control panel, if
prompted.
Read these instructions before using your product.
Note for Spanish speakers/Nota para hispanohablantes: Para
obtener instrucciones de configuración en español, consulte la Guía de
instalación en epson.com/support/xp960sp (requiere una conexión a
Internet).
1
Unpack
Note:
• Do not open ink cartridge packages until you are ready to install the
ink. Cartridges are vacuum packed to maintain reliability.
• The CD/DVD tray is taped to the bottom of cassette 2.
1
Remove all protective materials from the product.
2
Lift up the scanner unit and remove all protective
materials.
3 Lower the scanner unit.
2
Turn on and configure
1
Connect the power cord to the back of the printer and to
an electrical outlet.
Caution: Do not connect to your computer yet.
2
Turn on the product, then adjust the control panel.
3
Select your language.
Note:
• You can change the language later using the product’s control
panel. For more information, see the online User’s Guide.
• If an error message appears, turn off the product and check
that no protective material has been left inside the product.
3
Install ink cartridges
1 Lift up the scanner unit.
Caution: Do not touch the flat, white cable.
2
Unpack the ink cartridges.
Caution: Do not touch the areas shown below. Doing so may
prevent normal operation and printing.
3
Remove the cap from each ink cartridge. Store the caps in
the included plastic bag.
Note: Save the caps and use them to recap the ink cartridges
after removing them for storage or disposal.
4
Insert the cartridges at an angle in the holder for each
color. Press each cartridge down until it clicks.
5
Lower the scanner unit.
6
The printer starts charging the ink. Ink charging takes
approximately 7 minutes. When you see a completion
message on the printer’s LCD screen, charging is
complete.
Caution: Don’t turn off the printer or raise the scanner unit while
the printer is charging or you’ll waste ink.
Note: The cartridges included with the printer are designed
for printer set up and not for resale. After some ink is used for
charging, the rest is available for printing.
4
Load paper
Output tray
Cassette 1 Cassette 2/front cover
XP-960 Small-in-One
®
Printer
To Next Page
Loading...
Need help?
General
