Epson HDBaseT ELPHD01 - User Manual

• N

  Nichole AndersonAug 11, 2025

  Why no images appear on my Epson Transmitter?

  

  Same questionReply

  • J

    Jerome CruzAug 11, 2025

    If no images appear on your Epson Transmitter, please check the following: * Ensure the power is on and the Power indicator is green. * Verify the HDMI cable is securely connected to both the video equipment and the Transmitter. * Confirm the LAN cable is correctly connected, the Link indicator is green, and you are using a category 5e or category 6 straight STP cable. * Check that the HDMI device is turned on and playing an image. * Make sure all necessary cables were connected before turning on the device. If the issue persists, try turning the power off and then back on for all connected devices.

    

    Reply
• R

  Rachel AlvarezAug 18, 2025

  What to do if the image is blurred on my Epson HDBaseT ELPHD01?

  

  Same questionReply

  • C

    clarkjoshuaAug 18, 2025

    If the image from your Epson Transmitter appears blurred: * Check that the Link indicator is green and you are using a category 5e or category 6 straight STP cable for the LAN connection. Do not use a UTP cable. * Ensure the earth wire is grounded for stable communication with the projector. * Verify the LAN cable is not tied to other cables, as this can cause noise.

    

    Reply
• K

  Kristen GarzaAug 26, 2025

  How to fix no HDMI audio output on Epson Transmitter?

  

  Same questionReply

  • K

    Kristin BurnsAug 26, 2025

    If there is no HDMI audio output from your Epson Transmitter, and you're using an HDMI cable to connect the devices, set the connected equipment to PCM output.

    

    Reply
• J

  Johnny WalkerSep 3, 2025

  What to do if I cannot communicate with Epson HDBaseT ELPHD01 Transmitter?

  

  Same questionReply

  • V

    Victor KramerSep 3, 2025

    If you cannot communicate with your Epson Transmitter via LAN, RS-232 In, or Wired-IR In ports: * Verify that the HDBaseT function is enabled for the connected projector by checking the projector's settings. * Ensure the device has not entered sleep mode. In sleep mode, control from the RS-232 In or Wired-IR In ports is disabled. Set the [Sleep Mode] switch to [Disable]. * Avoid turning the power on/off or connecting/disconnecting cables during communication, as this can cause a communication error.

    

    Reply

Epson HDBaseT ELPHD01 Specifications

Print Specification

General

Category	Transmitter
Technology	HDBaseT
Input Ports	HDMI
Output Ports	HDBaseT
Power over HDBaseT (PoH)	Yes
HDCP Support	Yes
EDID Management	Yes
Transmission Distance	Up to 100m
Supported Resolutions	Up to 4K
Power Supply	5 VDC
Operating Temperature	0 to 40°C
Storage Temperature	-20 to 60°C
Weight	200g

Related product manuals

Epson WirelessHD

64 pages