Quick Setup
IMPORTANT: Before using this product, make sure you read these instructions
and the safety instructions in the online User’s Guide.
Choose a location
Keep the projector level and place it at a height so its lens is even with the top
or bottom of the screen and is centered horizontally. If this isn’t possible, use
the lens shift feature or the keystone correction button on the projector to
reposition the image (see “Adjust the image”).
In order to view 3D images correctly, RF 3D glasses must be worn within 32 feet
(10 m) of the projector. Use the image below to determine the viewing distance
for 3D projection (the shading represents the 3D viewing area):
See the online User’s Guide for more information on where to place your
projector.
Connect the projector
Choose from the following connections. For additional connection types, see
the online User’s Guide.
Video device
1
Home Cinema 5050UBe: Remove the cover as shown below.
2
Connect multiple video devices and use the Source buttons on the remote
control or the Source button on the projector to switch between
them.
HDMI cable
Optical HDMI
Note: When connecting a source that requires HDCP 2.2, you must use
the HDMI1 port.
WirelessHD™ Transmitter (Home Cinema 5050UBe)
Follow these steps to set up the included WirelessHD Transmitter.
HDMI
1
Place the transmitter within 32 feet (10 m) of the projector. Make sure the
front of the transmitter faces the front of the projector. See the online
User’s Guide for more information on the WirelessHD transmission range.
32 ft
(10 m)
16 ft
(5 m)
32 ft (10 m)
16 ft (5 m)
Note: Do not place the transmitter on a metal surface, as this may
interfere with the signal. Make sure there are no obstructions between
the transmitter and the projector.
2
Plug the AC adapter into the transmitter and a wall outlet.
3
Connect the HDMI cables to your video input devices and the HDMI ports
on the side and back of the transmitter. You can connect up to four input
devices to the transmitter. See “Viewing WirelessHD content” on the back
of this sheet for information on switching between input sources.
Note: You can connect tablets, smartphones, and other devices that
support the MHL™ standard to the HDMI port on the side of the
WirelessHD Transmitter. Some devices may require an adapter or may not
require an MHL cable. Not all features or functions may be supported.
Check your device’s documentation for more information.
4
To use the transmitter as a pass-through device to a television or other
display, connect an HDMI cable to the display device and the HDMI output
port on the rear of the transmitter. See “Viewing WirelessHD content” on
the back of this sheet for information on switching between wireless and
wired display modes.
Home Cinema 5050UB/5050UBe
To Next Page
Need help?
General
Weight and Dimensions
