EN
SV
NO
FI
DA
5
22
Reading the Indication Lights
: On : Flashing
Normal Status
The printer is connected to a wireless (Wi-Fi) network.
The printer is connected to a network in Wi-Fi Direct (Simple AP) mode.
Error Status
Wi-Fi connection error has occurred. Press the button to clear the error and try again.
Initial ink charging may not be complete. See the Start Here to complete initial ink charging.
No paper is loaded or more than one sheet has been fed at a time. Load paper and press the or
button.
A paper jam has occurred. Remove the paper and press the or button.
& ”Clearing Paper Jam” on page 33
If the indicator light continues ashing, see the jammed paper section from “Solving Problems” in the
User’s Guide.
The printer was not turned o correctly. After clearing the error by pressing the or button,
cancel any pending print jobs. We recommend performing a nozzle check because the nozzles may
have dried or clogged.
To turn o the printer, make sure you press the
button.
O Flashing simultaneously: An ink pad is nearing or at the end of its service life.
O Flashing alternately: A borderless printing ink pad is nearing or at the end of its service life.
Borderless printing is not available, but printing with a border is available.
To replace the ink pad or borderless printing ink pad, contact Epson or an authorized Epson service
provider.
The printer has started in recovery mode because the rmware update failed.
For more details, see the error indicator table from “Solving Problems” in the User’s
Guide.
A printer error has occurred. Open the front cover and remove any paper inside the
printer. Turn the power o and on again. If the error continues to occur after turning
the power o and on again, contact Epson support.
To Next Page
Loading...
Need help?
General
