60 Using the Projector on a Network
224.0.0.0 to 255.255.255.255 (where x is a number from 0 to
255).
5. If your network environment uses an AMX controller, select
ON
to allow the projector to be detected by AMX Device Discovery.
Using a Browser to Control the Projector
You can use a standard web browser to monitor and control the
projector through the network.
1. Make sure that the projector is set up for your network, as
described on page 54. (Standby Mode in the Extended menu
should be set to
Communication On to monitor the projector in
standby mode.) When using a browser to access the projector, you
cannot connect through a proxy server.
2. Open your web browser and enter the IP address of the projector
you want to monitor in the browser window.
If you’re not sure what the address of the projector is, turn the
projector on and select
Net. Info.-Wired LAN from the Network
menu to display the IP address of the projector.
3. Click
OK, or, if you set a Web control password in the projector’s
Network menu, enter your user name and password, then click
OK.
4. Select one of the menu options listed on the screen, then change
any of the settings as needed. These settings correspond to those
found in the projector’s menu system.
You cannot change the following settings using a web browser:
■ Pointer Shape, Test Pattern, or User Button in the
Settings menu
■ User’s Logo, High Altitude Mode, Lens Cover Timer and
Language in the Extended menu
■ Reset All and Reset Lamp Hours in the Reset menu
To Next Page
Loading...
Need help?
General
Weight and Dimensions
