92 Solving Problems
Flashing
orange
Rapid cooling is in progress. Although this is not an abnormal condition,
projection will stop automatically if the temperature rises higher. Make
sure there is plenty of space around the projector for ventilation, and that
the air filter and vents are clear. If you’re using the projector above 4900
feet (1500 m), turn on High Altitude Mode; see page 75.
Red The projector is overheating, which turns the lamp off automatically.
Wait until the cooling fan stops, then unplug the power cord. Plug the
power cord back in and press the
Ppower button. Make sure the room
temperature is not above 95 °F (35 °C), and there is plenty of space
around the projector for ventilation. If you’re using the projector above
4900 feet (1500 m), turn on High Altitude Mode; see page 75.
The air filter or vent may be clogged. Clean them or replace the air filter
as described on page 79.
If the projector continues to overheat after you clean the air filter, the
problem may be caused by damage to the cooling fan or temperature
sensor. Contact Epson for help as described on page 102.
Warning: Except as specifically explained in this User’s Guide, do not
attempt to service this product yourself.
Flashing
orange
It’s time to replace the lamp. See page 80 for instructions. If you continue
to use the lamp after the replacement warning, there is an increased
possibility that the lamp may break.
Flashing red The lamp may be burnt out. First make sure the lamp cover is securely
installed. If that’s not the problem, let the lamp cool, remove the lamp,
and replace it as described on page 80.
The air filter or vent may be clogged. Clean them or replace the air filter
as described on page 79.
If this does not resolve the problem, contact Epson as described on
page 102.
Flashing red Power is cut off because of an internal problem. Unplug the power cord
and contact Epson for help, as described on page 102.
Flashing red The auto iris or ballast is malfunctioning. Unplug the power cord and
contact Epson for help, as described on page 102.
Status lights (continued)
Light Status Description
To Next Page
Loading...
Need help?
General
Weight and Dimensions
