Charging the 3D Glasses
Charge the glasses when the status light on the glasses flashes red to indicate a low battery.
1. Connect the smaller end of the charging cable to the port on the bridge of the glasses.
Note: Make sure you connect the cable in the correct orientation or you may damage the glasses or
cable.
2. Connect the other end of the cable to the USB Type A port on the projector or any other device such
as a computer that has an active USB Type A port.
Note: The projector must be turned on to charge the glasses.
The glasses are fully charged when the status light on the glasses stays green.
Parent topic: Viewing 3D Images
61
To Next Page
Loading...
