KB / FAQ
Epson PX700 - PX730WD
Note: This guide also covers the following Epson printer models:
PX700W, PX710W, PX720WD, PX730WD
PX800FW, PX810FW, PX820FWD, PX830FWD
TX700, TX710W, TX720WD
TX800FW, TX810FW, TX820FWD
Artisan 700, 710, 725, 735
Artisan 800, 810, 835, 837
This guide is primarily aimed at OctoInkjet customers who have purchased a Solo-X waste kit (released May
2011) although customers with the earlier Solo+ can still apply some of the steps to their kit (but without a
part to act as the strain relief).
Note: This guide is copyright of OctoInkjet. It required 12 hours, the purchase of three printers (to check it
was all correct) and hard work to produce.
Please, if you see my work reproduced elsewhere, please report it to me, eBay (if provided by one of the
sellers there) or the appropriate authority so it can be removed. Competitors do not do the hard work, barely
understand the product and will not provide this level of documentation or support themselves so please do
not reward them by buying their kits.
OK... here are the step by step instructions fitting a Solo-X waste kit to a compatible printer.
1/4
To Next Page
Need help?
General
