IMPORTANT
If your printer is new, set it up according to
the enclosed manufacturer’s instructions.
This is a check to ensure your new printer
and drivers are working correctly before the
Eco-Flo System is installed.
ECO-FLO CONTINUOUS INK SYSTEM PermaJet
Assembly Instructions for: R3000 Ink System
It is very important you read these instructions carefully before you begin.
What you will need to Install the Eco-Flo R3000 What is included in your Eco-Flo R3000 Kit
Complete Eco-Flo R3000 kit Injectors set with tubes and white clamps
Scissors Lid deactivation key
Paper towels Set of 9 empty 100ml bottles
Set of 9 bottle caps & clear piping tubes
Bottle holder tray
1 grey tube clip with adhesive pad
2 lid support pads
Installation instructions and profiles CD
10ml syringe & wing adaptor
Pair of latex gloves
9x Image-life 125ml ink set
PermaJet A4 Media Test Pack
Check Printer Condition
If you have a brand new printer, follow the Epson instructions for setting up your printer. Use the Epson cartridges
that came with the printer. Follow normal installation instructions for the software. Test the printer by printing
pictures. Learn how to use the Epson utilities to run a Nozzle pattern check and to run a Cleaning Cycle.
Make sure that the printer can produce a perfect nozzle pattern
before proceeding with Eco-Flo installation.
To Next Page
Need help?
General