Start Here
3 Squeeze the edge guide as you slide it all the way to the
left.
4 Load letter or A4-size paper against the right edge and
behind the tab, with the printable side face up.
5 Slide the edge guide over.
Continue with section 6 to choose your connection type.
Read these instructions before using your product.
1
Unpack
French control
panel stickers
(included for
Canada only)
Power cord
Caution: Do not open ink cartridge packages until you are ready to
install the ink. Cartridges are vacuum packed to maintain reliability.
Remove all protective materials.
2
Turn on
1 Connect the power cable.
Caution: Do not connect to your computer yet.
2 Press the On button.
3
Select language
1 To select English as your language, press Start.
Note: If you want to change the language, press or to
select it, then press Start.
4
Install ink cartridges
Note: Do not load paper yet.
1 Lift up the scanner, then open the cartridge cover.
2 Shake the ink cartridges gently 4 or 5 times, then unpack
them.
3 Remove only the yellow tape from each cartridge.
Caution: Don’t remove any other seals or the cartridges may
leak.
4 Insert the cartridges in the holder for each color.
5 Press each cartridge down until it clicks.
6 Close the cartridge cover. Press down until it clicks.
7 Lower the scanner.
8 Press the Start button to charge the ink.
Priming takes about 2 minutes.
Note: Your printer ships with full cartridges and part of the ink
from the first cartridges is used for priming the printer.
Caution: Don’t turn off the printer while it is priming or you’ll
waste ink.
5
Load paper
1 Open the paper support and pull up the extensions.
2 Open the output tray, pull out the extensions, and raise
the stopper.
Epson Stylus
®
NX420 Series
To Next Page
Need help?
General
