5.2.10.2
PFP Adjustment
Printing the PFP Adjustment Pattern
1.
Load 4 x 6 Premium Glossy Photo Paper on the paper support.
2.
Select [PFP Adjustment] in the adjustment program.
3.
Click the [Print] button on the “ 1. Print Test Pattern” column to print the
adjustment pattern.
Scanning the PFP Adjustment Pattern
4.
Set the PFP Base Scale and the PFP test pattern on the document table and click
the [Scan] button on the “ 3. Scan Test Pattern” column.
5.
According to the scanned result, PFP calibration values are automatically
calculated and are written to the serial flash ROM. If an error occurs, check that
the document table glass and the scale is clean, and the scale/adjustment pattern is
not tilted, then repeat from step 4.
Scanner Origin
Position
Figure 5-27. PFP Test Pattern
Printer Identification
Code
PFP Base Scale
PFP Adjustment
Pattern
(4 x 6 size)
Scanner Document
Table
Figure 5-28. PFP Base Scale and PFP Adjustment Pattern Position
(As seen from the document glass of the scanner)
� � � �
� � �
Be careful of the following when setting the PFP Base Scale and the
adjustment pattern on the scanner.
Place the scale on the document glass aligning the scale corner
with the scanner origin position.
Place the pattern-printed sheet along the scale as shown in the
figure below. Make sure to place it parallel to the scale, with no
gaps.
In the adjustment program, the identification code is used to
distinguish whether the printer that printed the pattern and the
printer to register the adjustment value is the same.
To Next Page
Loading...
