PAGE 1 of 9 >>
Epson Stylus Pro 7700/9700/7890/9890
Network Printer Sharing
1.) Ensure the network cable is connected to the printer and the printer is powered ON. To nd your IP
address, press the Right (menu) button located on the control panel of the printer (see FIGURE 1)
FIGURE 1
2.) Press the Down button to locate/highlight NETWORK SETUP, then Press the Right button to select
NETWORK SETUP (see FIGURE 2).
FIGURE 2
NOTE: DHCP must be enabled in your network conguration. In a DHCP environment, the IP
address may change periodically. As a result, this procedure will need to be repeated each time
the IP address changes.
IMPORTANT: Before proceeding, please ensure the Epson (OEM) printer driver and Sawgrass
PowerDriver or Winprole have been installed. For assistance with driver or prole installation, please
refer to the Installation Guide.
1
2
1
To Next Page
