3
4
Open the front cover. (The cover has special tabs
that act as paper supports when the cover is open.)
5
Feed the posterboard into the paper slot until it
meets resistance.
Note: If you’re using stock more than 39 inches
long (Epson Stylus Pro 9800 only), load it long edge
first (in landscape orientation).
6
Align the board with the mark on the roll paper
cover.
7
Return the paper lever to the locked position. Then
close the front cover.
8
Press the Pause button. The board feeds into
the printing position automatically and READY
appears on the control panel.
9
Run your print job. After it is finished, the
posterboard stays in the printer.
10
To remove the print, hold it and release the
paper lever.
SP7898_QRGin_CPD20272.indd 3 8/5/05 10:15:29 AM
To Next Page
Loading...
