Setting Up Your System for Network Printing 17
7. Press r, then press u or d to choose one of the following IP configuration
settings:
❏ Choose PANEL if you would like to set the printer’s IP settings
manually (recommended).
❏ Choose AUTO if your network uses a DHCP server to provide IP
addresses automatically. The printer’s IP address will be obtained from
the DHCP server whenever the printer is reset or turned on, but may
change as IP addresses are reassigned over time.
8. Press OK. A checkmark (✓) appears next to the setting you selected.
9. Press l to go back, then do one of the following:
❏ If you selected PANEL as the IP address setting, continue with step 10.
❏ If you selected AUTO as the IP address setting, press the Pause/
Reset button to exit the printer menu. Then continue with step 14.
10.Press d to highlight IP,SM,DG SETTING, then press r. The LCD displays
the IP address.
11.Press u or d to change each octet value, then press r to select the next
octet. When you have changed the value of the last octet, press r. The
LCD displays the subnet mask.
12.Press u or d to change each octet value, then press r to select the next
octet. When you have changed the value of the last octet, press r. The
LCD displays the default gateway.
13.Press u or d to change each octet value, then press r to select the next
octet. When you have changed the value of the last octet, press OK and
then press the Pause/Reset button to exit the printer menu.
14.Turn the printer off then back on again.
c
Caution:
After turning off the printer, wait until the status lights go off before turning it
back on; otherwise the network interface may not work correctly.
15.See “Printing a Network Status Sheet” below to print a network status
sheet and confirm the new IP address, which you’ll need during setup. You
can also use the EpsonNet Config software to obtain the IP address.
To Next Page
Loading...
