3
14) When the printer driver installation is ready to begin you will see a Driver Installation Warning
dialog box. Click OK.
15) When the files have finished copying to your hard drive, you should see the StylusScan Utility
Setup dialog box. The message should say, "Driver installation and port configuration were completed
successfully." Click OK. Then click Restart.
Note: After you restart your computer, Windows may redetect the printer on your Stylus Scan product
and automatically install a driver. Do not try to interrupt this process. It will not affect the installed
Epson drivers.
16) Open the Printers window. You should see a printer icon labeled Epson Stylus Scan 2000 or
Epson Stylus Scan 2500. Verify it has a checkmark next to it and that it says Ready. Verify printer
communication by running a test page. If you want to test both the scanner and printer at the same
time, launch Smart Panel and use the Copy utility. For more information on how to use Smart Panel,
refer to your User’s Guide.
Note: If the Stylus Scan does not say Ready, then right-click on the icon and click on “Set as
Default”.
To Next Page
Loading...
Need help?
General
